ArduPilot Mega APM2.8 - NTF_DISPLAY_TYPE config mod

Hardware UnSupported hardware
1

Hi,

I recently acquired a second-hand APM2.8 flight controller board (I know it’s old, but I got it for about 30USD + other drone stuff), and I’ve been wondering if I can somehow mod the firmware to allow for the “NTF_DISPLAY_TYPE” config. I’m running AP 1. 3. 0. and that doesn’t support it.
The reason for this is connecting one of those OLED info displays meant for Pixhawks.

Looked online, and I don’t think anyone has attempted something like this before. Theoretically, it should be possible; the 12C port is shared between the 2 boards and thus should be compatible. “Custom Firmware Builder” does not help with firmware this old.
I realise that the chance is slim, but if anyone has any ideas, it would be highly appreciated.

Thanks Dr880

2

You are on your own, the server only goes back to 4.3 and APM 2.8 was supported up to 3.2.1 (copter) or 3.3 (plane).

IMHO it is a total waste of your time. Did you get any other hardware from the list?

3

Thank you for your help.

It was a box of old drone parts I got off a 2nd hand market. It was full of random FPV frames, motors, ESCs, and even a DJI NAZA. I think the guy was selling off his old hobby parts, but honestly, I did not ask.