Zerodrag_BOOST_55A_55A_4-in-1_ESC_Manual_compressed (1).pdf (578.6 KB)
I’m using Zerodrag 4in1 esc along with cuav v7 nano fc.I connected 4 signal wires and gnd from esc to M1 M2 M3 and M4 pins signal and gnd to one gnd in fc using a custom made wire .Then mot_pwm_type changed to dshot300 and when i try to do motor test in mission planner,in messages it shows motor test start and then finished.But motor is not spinning.What will be the reason?
Regards Abhijit