About the Plane 3.7 category
AutoTakeOff: engine starts but only with about 30% power
Can a plane navigate a mission without the compass?
ArduPlane Altitude Control Source Code
MAVSerial pass to GPS
LUA Script for APM Plane & QuadPlane
The Plane passes twice on the same route!
Trouble assigning channels to transmitter
Why decreased the altitude when RTL?
No log files or folder created
[SOLVED] BRD_SBUS_OUT = 1 doesn't work, any ideas?
Airplane wont AutoTakeOff - "Bad launch AUTO"
Crashed in take off with firmware "Arduplane 3.7.1",Why?
Auto-Take-Off Vertical climb then loop and crash
Flat turns in auto
The Altitude was different by 20 meters
Big alt lose when switch into RTL
Logging check is not enforced
Telemetry 2 baud rate
Hardware-in-the-loop simulation - HIL - simulation
Telemetry not logging
Throttle lowers when i switch to FWBA mode
FBWA crashed my plane
Pixhawk output rail does not give any output
SBUS Failsafe Flag(s)
Struggle to keep constant altitude in GUIDED, is GUIDED wrong for what I want to accomplish?
FailSafe on AUX pins
Arduplane v3.7.1? If EKF_ENABLE = 1, EK2_ENABLE = 0, and AHRS_EKF_TYPE = 2, whats running inside?
Cannot get telemetry logs
next page →