Servers by jDrones

ArduPlane   Plane 3.3


Topic Replies Activity
About the Plane 3.3 category 1 May 20, 2015
Pixhawk deploys flap to maximum position on failsafe 7 May 5, 2021
MRO Control has acting erratically and won't boot 2 February 20, 2021
Pixhawk digital airspeed sensor makes horizon pitch unstable 11 January 18, 2021
APM Plane 3.3.0 Firmware still exits? For the board APM 2.6 6 July 25, 2020
APM 2.8 Compass 1 Error: 99 [SOLVED] 4 June 21, 2020
Can you overrride the absurd 8000cm RTL_ALT limit somehow? 8 June 2, 2015
Cannot connect to a com port in mission planner 9 January 28, 2020
Solving barometer drift 13 January 12, 2020
How to do digital airspeed sensor calibration 2 November 22, 2019
RSSI from channel 8 Failsafe 1 May 25, 2019
RPM in Arduplane-3.3.0 6 April 25, 2019
Plane flips over when RTL engaged 4 January 24, 2019
Continuous stalling during auto mission 15 October 12, 2018
PPM Redundancy 6 September 6, 2018
PreArm: logging not available after update 2 January 18, 2018
The ArduPlane 3.3 version in APM 2.5, includes the FrSky telemetry protocol through smartPort? 4 December 12, 2017
Auto-take off veering to right but not in manual (Skywalker on a dolly) 2 September 21, 2017
Is there a version of Plane for old 8bit card that will compile on Arduino? 1 August 17, 2017
Negative value for flight mode? 1 June 23, 2017
EKF, EK(F)2, EK(F)3, etc. What is the difference 3 January 31, 2017
APM 2.5.2 firmware verification error 3 January 31, 2017
Trims on different flight mode 1 December 5, 2016
APMPlane 3.3.0 Bad LIDAR Health 19 October 10, 2016
HIL not working in Release 3.3.0 9 October 5, 2016
POS Horizon Variance and Velocity Variance Errors 4 September 17, 2016
APM 2.6 with ver 3.3 arduplane mode help! 4 August 22, 2016
Flight mode changes to manual when throttle is advanced 5 August 8, 2016
Y configuration Quadplane? 1 July 15, 2016
Camera Gimbal Issues 1 June 27, 2016
Servers by jDrones