Servers by jDrones

ArduCopter


Topic Replies Activity
LIDAR Lite v4 set up with PIXHAWK PX4 2 February 11, 2020
Free Stuff! Need Help Testing devFrame 5 February 10, 2020
HERE GNSS no gps lock for device 1 February 10, 2020
Pixhawk 2.4 RTL mode issue 4 February 10, 2020
Limit height and avoid obstacles on top of the drone using TOF sensor 4 February 10, 2020
Can't calibrate sensors 13 February 10, 2020
Cabling Questions: Upgrade from Pixhawk1 to Avioni Hex Board with Orange Cube 4 February 9, 2020
Running two or more versions of mission planner on same computer 3 February 8, 2020
Radiolink mini pix turbo 1 February 7, 2020
Low Altitude warning in Copter 3.6.12 stable official verison 1 February 7, 2020
Three months of Crazy Loiter and Althold. Help me, please 16 February 7, 2020
Increasing imu stream rate 9 February 7, 2020
Default parameter set for sub 250 multirotors 40 February 6, 2020
MAVLink routing - some messages are not forwarded 3 February 6, 2020
Executable file generation 4 February 5, 2020
Pixhawk Mavlink Commands autorotate to home position 1 February 5, 2020
Frsky Passthrough Telemetry "New Sensors" Not Discovered 2 February 5, 2020
Cube purple unable to calibrate compass [firmware 4.01] 1 February 5, 2020
doubt in ardupilot as a beginner 2 February 4, 2020
Regarding the setting of the parameter MAG_CAL = 5, it affects the radio and GCS links 1 February 2, 2020
PID tuning for Agri Drone which is heavy 5 February 2, 2020
Unable to download params from pixhawk cube to raspberry pi 4B 1 February 1, 2020
Rangefinder I2C Setup 1 February 1, 2020
Error running sim_vehicle.py 21 January 31, 2020
Predictive parachute package delivery using real-time trajectory algorithm 4 January 31, 2020
Wall locking drone 1 January 31, 2020
How to not exceed a set ground speed in pos hold mode 7 January 30, 2020
Holybro Pixhawk 4 error. Says "RC16 minimum value greater than trim" 2 January 30, 2020
Mission planner denied connection 1 January 30, 2020
Fast forward flight causes craft to lean to frnt left motor 2 January 30, 2020
 
Servers by jDrones