Servers by jDrones

ArduCopter   Copter 3.3


Topic Replies Activity
About the Copter 3.3 category 2 April 17, 2017
Bebop WIFI connection mode 2 June 17, 2019
Moving base not operational 4 May 24, 2019
Remaining battery always shows 99% 4 February 28, 2019
ServoOutput passthrough and Chanel matrix question 5 December 26, 2018
ESC restarting on mid-flight 11 November 22, 2018
Set param error 18 November 11, 2018
How long Autotune? 12 November 8, 2018
Inconsistent compass 13 November 7, 2018
Motor Calibration using mikrokopter bl-ctrl V2.0 3 October 26, 2018
Overheat PID - problem choosing the right ones values 22 October 26, 2018
Problem: Stick input delay (1s) with FRSKY d8r-ii plus SBUS 1 September 26, 2018
Two motors spin at the same time when motortest 8 September 5, 2018
Autotune Crash 17 August 31, 2018
Behaviour if RC Failsafe triggered but no GPS signal 2 July 28, 2018
Accelerometer Calibration Failed 8 July 26, 2018
Tuning PIDs for very large quadcopter 5 July 13, 2018
Large X4 Quad, not sending consistent power to motors 5 July 9, 2018
ADNS3080 on the Pixhawk 7 June 22, 2018
Perplexity about the EKF running cycle 4 April 17, 2018
Joystick CH 6 CH 8 1 March 20, 2018
Loiter_Unlimited next command 2 March 15, 2018
Mavlink controlled alexmos gimbal moves yaw in wrong direction 2 March 7, 2018
Two external compass modules on pixhawk fw 3.3.3 9 February 26, 2018
Control Shutter and Camera Power on RC10 (Seagull Map) 8 February 4, 2018
Is it possible to use ardupilot to control quadcopter with 4 gasoline engine? 22 January 22, 2018
Where can I find MavLink messages code #166 4 January 19, 2018
What is the benefit of running multiple compasses on Pixhawk? 9 January 12, 2018
How to assemble ArduCopter pi 3 with raspberry pi 3? 2 January 7, 2018
Auto mission problems 1 December 27, 2017