Servers by jDrones

ArduCopter   Copter 3.2


Topic Replies Activity
Read first: How to use this forum 3 April 25, 2019
Arducopter 3.2 Stable: Important Bugs List 7 September 25, 2017
About the Copter 3.2 category 1 September 18, 2013
AC3.2-rc1 Known Issues & Release Notes 27 November 19, 2015
Motors run full whenever above idle 6 June 11, 2021
Trouble with osd apm 2.8 4 June 8, 2021
Ardupilot Issue ARMING_CHECK 1 June 8, 2021
Flips on takeoff 17 June 7, 2021
What could be the reason of different servo output for neutral position? 8 June 6, 2021
Channel 5 does not change the flight mode! 3 June 6, 2021
Uneven servo outputs APM 3.2 3 June 5, 2021
How to use Dshot1200 BL heli esc with APM 2.8 2 June 5, 2021
Can't enable sonar in mission planner 10 May 29, 2021
F450 setup apm 2.8 not lift after armed 7 May 22, 2021
Use Sonar/RangeFinder & Optical Flow Sensor at the same time 4 May 18, 2021
Drone goes crazy after 3 minutes of flight (overweight after attaching gimbal?) 4 May 18, 2021
Sonar cannot be checked to enable in Mission Planner? 9 May 17, 2021
Weird Gimbal Behavior [solved] 2 May 14, 2021
Cannot Arm Quadcopter (APM 2.8) with Spektrum DX6e 2 May 12, 2021
Please analyze my drone's attitude behavior in air and check if PID corrections are needed (log attached) 2 May 11, 2021
Motors to 1% after auto landing but not disarming, why? 7 May 1, 2021
Flight modes not switching? 4 April 13, 2021
High osclillations on landing with wind! PID tuning? Or underpowered motors? 8 April 12, 2021
Suddenly different compass offsets after calibration 6 April 2, 2021
Does power module need current (amps) calibration? 3 March 25, 2021
Apm 2.8 is not being configured Intlo esc calibration mode for all at once esc calibration 2 March 23, 2021
GPS High HDOP error while arming almost every time 8 March 15, 2021
New Setup Help, too crisp, hover issue 43 March 2, 2021
Apm 2.8 flight controller goes crazy after connecting battery 1 February 25, 2021
Controls fliped or changed 1 February 23, 2021
Servers by jDrones