Servers by jDrones

ArduCopter   Copter 3.1


About the Copter 3.1 category (1)
Welcome v3.1 and thanks dev team ( 2 ) (37)
Read first: How to use this forum (1)
Bad channel 1 input, cancelling (1)
Arming problem - FS_THR_VALUE (10)
Pre Arm: Check_FS_THR_VALUE (4)
Jeremi_hazan@walla.com (2)
DJI M100 possible to control from mission planner (2)
RC not calibrated error (10)
Need help on connection between Arduino and APM 2.8 for simple Sonar Obstacle avoidance (1)
Modifying Traditional Heli (8)
Gets binding error calibrating Compass (1)
Gps module otherthan neo (4)
How to properly use DO_SET_ROI? ( 2 ) (22)
hMotors doesn't start slow spin when armed with BlHeli ESC (10)
Apm mini 3.1 motor 4 won't spin (1)
Apm mini 3.1 Can not set logging on (1)
Copter 3.1 tuning problem (3)
Quad Fell out of Sky (5)
APM2.8 ir-loock (1)
R12DSM Receiver Help! (6)
Help with telemetry parameters (9)
HW:Apm 252 SW:3.1.5 - flash chip replacement (1)
Setting the maximum descent rate in APM (8)
Quad Crashes after thrusting vertically up (8)
Low KV Autotune problem (3)
New Flight mode SITL (4)
APM V3.1 Channel in and Channel out (11)
Problem apm 2.6 (5)
Translate ptich/roll angle to PWM output for servos? (2)